Jump to content

matthijs

Recommended Posts

It's the tuning stability if I had to pick anything, these mini Gotohs are a bit on the unresponsive side :(

 

You sure it's the machine heads? The 510s are a little smoother, but the standard gotohs are still some of the better machine heads out there. I would have a proper setup with the nut slots checked before replacing the machine heads.

Link to comment
Share on other sites

Next step is a Nailbomb & Nantucket in the LP studio ^^

 

Have you opened that one up yet? Because you might have to tear the entire thing apart and start over.

 

3464747842_d8fe453e85.jpg

 

That or figure out how to add those plastic connectors to the new pickup wires.

Link to comment
Share on other sites

Have you opened that one up yet? Because you might have to tear the entire thing apart and start over.

 

3464747842_d8fe453e85.jpg

 

That or figure out how to add those plastic connectors to the new pickup wires.

 

Yup, I did. The aluminum knobs Allen screws kind of fucked up 2 of the pots, so I had to switch them out. :facemelt: Oh well, 2015 model, guitar has no resell value anyway :facemelt:

 

I took it apart and what's interesting is that out of the two Mallory caps on the circuit board (for coil splits - the humbuckers have .022 orange drops), only one reads .032 and one .021. Both say .033uf though, which is... odd

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...